Direct answer: Research shows wet cassava peel can be turned into a storable feed ingredient if it is processed within a day, grated, pressed to remove water, briefly fermented, sieved and dried to 10 to 12% moisture. The method was developed and tested at small and medium scale. Industrial flash drying is proposed but, per the research manual, not yet tested.
Key takeaways
- Hand peeling of cassava creates very large volumes of wet peel. A CGIAR manual estimates up to 40 million tonnes of peel a year in Africa.
- The High-Quality Cassava Peel (HQCP) method from ILRI and partners uses grating, hydraulic pressing, overnight fermentation, sieving and drying.
- Pressing gives a cake of about 30 to 40% moisture and removes about half the water in raw peel. Dried mash at 10 to 12% moisture can be stored for four to six months.
- About three tonnes of wet peel give one tonne of dried fine mash, according to the manual.
- In laboratory tests reported in the manual, processed mash had no detectable aflatoxin and HCN well below a 100 ppm level considered safe for livestock, while traditional sun-dried peel samples had aflatoxin B1 around 19 to 22 ppb.
Why is cassava peel a problem and an opportunity?
Short answer: Fresh peel is wet, spoils quickly and contains cyanogenic compounds. Slow sun drying on open ground invites mould and aflatoxin. Yet peel is rich in starch and energy, so if it is dried quickly and safely, it can replace part of the grain in animal feed and turn a waste stream into a product.
The ILRI manual (Amole, Anandan and Okike, 2019) notes that Africa produces over 150 million tonnes of cassava roots a year and that more than 95% are hand peeled. Traditional sun drying of peel takes one to three days in the dry season but up to eight days in the rainy season. During that time many mould species can grow. Processed peel samples in the manual’s laboratory table contained roughly 75 to 80% starch.
What are the HQCP processing steps?
Short answer: Sort fresh peel, grate it three times, press it in bags to remove water, leave the cake overnight to ferment, loosen and sieve it into fine and coarse fractions, then dry to 10 to 12% moisture and bag. Each step has a clear purpose: faster drying, cyanide reduction or fibre separation.
- Sourcing: use fresh peel, ideally less than 24 hours old. Older peel ferments, becomes slippery and is hard to grate.
- Sorting: remove stalks, woody pieces and foreign matter that damage the grater.
- Grating: peel is grated three times because it is harder and smaller than whole roots. The manual cites about one hour for a 7.5 hp grater to grate 500 kg of fresh peel three times.
- Pressing: grated peel is packed in woven bags of about 20 kg and dewatered in a hydraulic press. The resulting cake has about 30 to 40% moisture.
- Overnight fermentation: the cake is left overnight. The manual says this initial fermentation is needed for quality and further removes hydrogen cyanide.
- Pulverising and sieving: lumps are loosened in a pulveriser or by another pass through the grater, then sieved on a motor-driven shaker with a sieve of about 2.5 mm. This gives a fine, lower-fibre fraction and a coarse, higher-fibre fraction.
- Drying: sun drying in thin layers (4 to 6 kg per m²) for six to eight hours, toasting in pans on rainy days, or flash drying proposed for industrial scale.
- Bagging and storage: pack at 10 to 12% moisture in woven bags and use first-in, first-out storage.
How much dried feed does a tonne of peel give?
Short answer: The manual gives a ratio of about three to one, wet peel to dried fine mash. So a site collecting 30 tonnes of fresh peel a day could expect roughly 10 tonnes of dried fine mash, before any losses. Measure your own peel moisture and yields, because cassava variety and peeling method change the numbers.
Worked example (illustrative): a starch or garri plant generates 30 t/day of fresh peel.
- Dried fine mash at the manual’s 3:1 ratio ≈ 30 ÷ 3 = 10 t/day.
- Pressing removes about half the water in raw peel, which greatly reduces the water a dryer must evaporate compared with drying raw peel.
- The remaining water, from 30 to 40% moisture down to 10 to 12%, is what the dryer must handle. Calculate it from your measured cake moisture and output, and include it in dryer sizing.
What does the safety data show?
Short answer: Laboratory results in the manual compared HQCP mash from three factories in south-west Nigeria with sun-dried peel from local markets. The processed mash had aflatoxin below the 1 ppb detection limit and HCN of about 2 to 8 ppm. Sun-dried peel samples had aflatoxin B1 of about 19 to 22 ppb and HCN of about 11 to 45 ppm.
The manual states that finished products made from fresh peel and processed consistently will have HCN below 100 ppm, a level considered safe for livestock feeding, and refers to a tolerable aflatoxin limit of 20 ppb, particularly for poultry feed. These are reported results from specific sites and a small number of samples. Any commercial feed product must be tested against the feed regulations of its market.
What is proven and what is not yet proven?
Short answer: The core grate-press-ferment-dry process has been used at small and medium scale, which the manual describes as one to three tonnes per week. Industrial-scale drying with flash dryers is recommended in the manual but described as not yet tested. Treat large plants as engineering projects needing trials.
- Demonstrated: process steps, moisture targets, storage life and laboratory quality results at the scales described.
- Proposed for scale-up: flash drying in place of toasting pans. The manual notes that a flash dryer malfunction can affect shelf life.
- Needs project-specific work: continuous grating and pressing at higher throughput, drained juice handling, dust control and feed-mill acceptance testing.
Which equipment does a larger plant need?
Short answer: The equipment types match those used in garri and cassava flour processing: graters, hydraulic presses, pulverisers, sieves and dryers. A larger plant replaces toasting pans with a mechanical dryer and adds conveying, weighing and bagging, plus a system for drained juice.
GTI’s cassava processing machinery page lists grating, dewatering, pressing, fermentation, drying and sieving stages, including cassava graters, hydraulic presses and flash, fluid bed and belt dryers. Applying these to peel needs trials on your peel. For dryer choice on wet fibrous residues, see gtidryers.com on dryers for cassava pulp, corn fibre and potato pulp, and epcprojects.in on rotary drum versus flash dryers for wet cakes.
What should a processor check before investing?
- Daily peel volume, its freshness at collection and its moisture.
- Buyers: feed mills, farms or integrators, and their specification for HCN, aflatoxin, fibre and moisture.
- Pilot trials to measure cake moisture, fine/coarse split and dryer evaporation.
- Handling of drained juice, which the manual directs to a soak-away pit at small scale.
- Laboratory testing plan for every batch in the early months.
Frequently asked questions
Can wet pressed cake be sold directly?
The manual says the 30 to 40% moisture cake can be fed to ruminants and pigs but has a short shelf life, about seven days in bags.
Is the coarse fraction useful?
Yes. The manual notes the coarse, higher-fibre fraction suits ruminants, while the fine fraction suits monogastric feeds such as poultry and pigs.
Related reading
- Cassava flour, chips and starch processing engineering guide
- The physics of flash drying cassava starch
- Flash dryer
Talk to GTI about your project
Looking to turn cassava peel or other residues into a saleable product? Contact Genex Tech Industries LLP (GTI Group) to discuss your material, production capacity, product specifications and utility requirements. To help us respond usefully, please share your product or raw material, required capacity, feed and final moisture (state wet or dry basis), finished-product specification, available utilities, installation location and project timeline.
Email: mktg@foodtechprojects.com
Call or WhatsApp: +91-93300-77417 | +91-87774-75596 (WhatsApp)
Website: https://foodtechprojects.com/
For Industrial Dryers: https://gtidryers.com
This article gives general technical guidance. Figures marked as illustrative are examples, not plant guarantees. Equipment selection and performance for your material should be confirmed through trials and engineering assessment.
References
- Amole T.A., Anandan S., Okike I. (2019). A guide to the production of High-Quality Cassava Peel mash as a feed for livestock. ILRI Manual 35. International Livestock Research Institute. cgspace.cgiar.org
- ILRI. New technology turns cassava peels into nutritious, affordable animal feed ingredient. www.ilri.org
